![]() It has an implementation of the GBRL protocol that is a little different than what we are used to because its focused on heat beds and hot ends and does not have spindle commands. ![]() The most often used software for this board is Merlin and together their main focus is on 3D printers. ![]() So to start the RAMPS board is just another controller board that is designed to run stepper motor's and control stuff. I had this all written and while reviewing it - it went poof and I had to start all over. I will be a little long winded here - and as a side not I hate computers. I wanted to start a new thread for this topic so it would not get lost in another thread with a totally different meaning.
0 Comments
Leave a Reply. |